Quick Start
The 2900 series comes ready with the following factory default settings in memories 1 - 5. These default settings will remain unless overridden with your own test program. Before beginning, please make sure the input voltage selector switch is set correctly on the back panel (115 or 230).
Defaults
- Input Voltage: 115 or 230 volts AC country specific (rear panel switch selectable)
- Lock: OFF
- Test: W
Dielectric Withstand Test Mode Defaults
- Voltage Output: 1,240 volts AC
- High Current Trip: HI-LMT: 10 mA
- Low Current Trip: LO-LMT: 0 mA (2925 and 2935)
- Ramp Timer: 0 second (2925, 2935, 2945)
- Dwell Timer: 1 second
- Voltage Type: AC
- AC Output Frequency: 60Hz
- Continuity: OFF
Insulation Resistance Mode (model 2945) Defaults
- Voltage Output: 1,000 volts DC
- High Resistance Trip: I - High: 0 MΩ
- Low Resistance Trip: I - Low: 1 MΩ
- Delay Timer: 2 seconds
To change factory defaults simply press the “set” key on the front panel. This will toggle through the following parameters:
- Memory
- Test
- W-Mode (shown on model 2945) or Mode (shown on model 2925 & 2935)
- W-Volt (shown on model 2945) or Volt (shown on model 2925 & 2935)
- W-High (shown on model 2945) or High (shown on model 2925 & 2935)
- W-Low (shown on model 2945) or Low (shown on model 2925 & 2935)
- W-Ramp (shown on model 2945) or Ramp (shown on model 2925 & 2935)
- W-Dwell (shown on model 2945) or Dwell (shown on model 2925 &2935)
- W-Freq (shown on model 2945) or Freq (shown on model 2935) (Available in AC Hipot Mode Only)
- W-Continuity (shown on model 2945) or Continuity (shown on model 2925 & 2935)
- I – Volt (2945 Only)
- I – High (2945 Only)
- I – Low (2945 Only)
- I – Delay (2945 Only)
The "up" and "down" arrow keys will toggle and change the settings on each parameter. Pressing exit will automatically save those parameters.
|
