Quick Start

The 2630 comes ready with the following factory default settings in memories 1 – 5. These default settings will remain unless overridden with your own test program. Before beginning, please make sure the input voltage selector switch is set correctly on the back panel of the instrument (115 or 230).

Defaults

• Input Voltage: 115 or 230 Volts AC country specific (rear panel switch selectable)
• Current Output: 25.00 Amps
• Resistance Trip (High): 100 mΩ
• Dwell Timer: 1 Second
• Frequency: 60 Hz
• Offset: 20 mΩ
• Lock: Key Unlock

To change factory defaults simply press the "set" key on the front panel. You will then be able to toggle through the above parameters. When you get to a parameter you wish to edit, the "up" and "down" arrow keys will change the parameter. Pressing exit will save the settings.