Front Panel Controls

1. RESET BUTTON: This is a momentary contact switch used to reset the instrument. If an out-of-range reading is detected during a test, the red failure lamp within the button will light. To reset the system for the next test, press and release this button. This button may also be used to abort a test in progress.
2. TEST BUTTON: This is a momentary contact switch used to start a test. Press the green button to turn on the high voltage output when in test mode. The indicator lamp within the button will light when test expires with pass condition.
3. LCD DISPLAY: The Liquid Crystal Display is the main readout for the operator and programmer of the test settings and test results.
4. LOCK: This LED indicates that the Lock feature has been enabled.
5. FAULT CONDITION INDICATORS: These LED’s indicate that the Neutral, Reverse, and Ground Line Conditions have been activated during a Line Leakage test.
6. CURRENT OUTPUT TERMINAL: This terminal is used for the connection of the detachable 6-foot red high current test lead. This terminal is always used when performing a Ground Bond test.
7. POWER SWITCH: Rocker-style switch with international ON ( | ) and OFF (0) markings.
8. SET KEY: Use this key to advance forward through the setup menus.
9. DOWN ARROW(∨): Use this key to decrease the numeric values in the setup mode. This key is also used to toggle ON/OFF functions. Also may be used to decrease output voltage during a test in 10-volt increments.
10. UP ARROW(∧): Use this key to increase the numeric values in the setup mode. This key is also used to toggle ON/OFF functions. Also may be used to increase output voltage during a test in 10-volt increments.
11. EXIT KEY: Use this key when you desire to enter the test mode to initiate a test. Also the key uses to enter the System menu parameters and to exit from the System menu.
12. HIGH VOLTAGE OUTPUT TERMINAL: For the connection of the detachable 6-foot red high voltage test lead. The silicone rubber insulation is flexible for easy handling and is rated at 30KVDC. The terminal is recessed for safety when this lead is not being used.
13. HIGH VOLTAGE ARROW (LED INDICATOR): This indicator flashes to warn the operator that high voltage is present at the high voltage output terminal.
14. TERMINAL OUTPUT TERMINAL: For the connection of the detachable 6-foot black return test lead. This terminal is always used when performing a test.