LCD DISPLAY: The Liquid Crystal Display is the main readout for the operator and programmer of the test settings and test results.
RESET SWITCH: This is a momentary contact switch. If a failure is detected during a hipot test or an IR test or if continuity failure occurs, the red failure lamp within the switch will light. To reset the system for the next test, press and release this switch. This switch may also be used to abort a test in progress.
TEST SWITCH: This is a momentary contact switch. Press the green switch to turn on the high voltage output when in test mode. The indicator lamp within the switch will light when continuity is present, if continuity mode is enabled.
POWER SWITCH: Rocker-style switch with international ON ( | ) and OFF (0) markings.
SET KEY: Use this key to advance forward through the setup menus.
DOWN ARROW (∨): Use this key to decrement numeric values in the setup mode. This key also used to toggle ON/OFF functions. Also may be used to decrease output voltage during a test in 10-volt increments.
UP ARROW (∧): Use this key to increment numeric values in the setup mode. This key also used to toggle ON/OFF functions. Also may be used to increase output voltage during a test in 10-volt increments.
EXIT KEY: Use this key when you desire to enter the Run Mode to initiate a test.
HIGH VOLTAGE OUTPUT JACK: For the connection of the detachable 6-foot high voltage test lead or test probe. The jack is recessed for safety when this lead is not being used.
HIGH VOLTAGE ARROW (LED INDICATOR): This indicator flashes to warn the operator that high voltage is present at the high voltage output terminal.
RETURN OUTPUT JACK: For the connection of the detachable 6-foot black return test lead or three-prong receptacle adapter box. This jack is always used when performing a test.
